Step 1: Place the mount  at the desired  location,  assuring that it is at least 20cm from the ceiling.  Use a pencil to mark the holes.

Step 2: Using a 6 mm drill bit, drill two 25 mm deep holes over  the  pencil  marks.  For  a plaster,  dr y wall,  or concrete wall, insert the plastic anchors to support the screws first.

Step 3: Place the mount over the holes that are in the wall. Make sure to align the mount holes with the holes in the wall. Use the supplied  screws to attach the mount to the surface of the wall.

Step 4: Rotate  the wing  nut counterclockwise  with  your fingers to slightly loosen it. Then move the bracket to the approximate desired position.

Step 5: S crew  the  camera  onto  the  mounting  screw  by tightening the plastic finger nut.

Step 6: Adjust the angle of the arm on the mounting bracket as required.Tighten the wing nut to lock the camera's position into place.